Evolution-engines 35GT2 Manual de usuario descargar pdf (Pagina 8)

Evolution GT2 Engine Easy Start Ignition System

The spark ignition included with your Evolution

gas engine is a modern generation electronic ignition. There are many useful functions

built into the microprocessor of this unit.

In addition to the basic ignition functions, the unit has a FAIL-SAFE feature: After 90 seconds of inactivity, it automatically switches to

an inactive state. In order to restart normal operation, it is necessary to turn the battery switch off and then back on. This function will

preserve battery life should the switch be left in the on position during inactivity.

Installation of the GT2 Easy Start Ignition Unit

While installing the ignition unit in your model, be careful to have all parts that are connected to the unit and the engine

situated as far as practical from the radio receiver and radio antenna. The throttle servo should be mounted a distance of

8–12 inches from the engine. The spark plug cable must not touch any part of the model structure as vibration may damage

the cable. If this is not practical, it will be necessary to provide an insulation material for the cable. The ignition unit itself

should be wrapped in foam rubber to prevent engine vibration from damaging the electronics. All components must be

protected from contact with engine fuel.

Technical data

Weight 155 g

Power supply 2x Li-lo/Li-Po

6x Ni-Cd/Ni-MH

Pre-ignition point 5º

L ocation of the magnet 240º / 120º

M inimum battery capacity 600mAh

Other features

Preset ignition curve

S leep mode after 90 seconds of engine inactivity

Battery level signalization

I gnition goes off if engine runs counterclockwise

LOW

BATTERY

SLEEP

MODE

SHORT

SILENCER

LONG

SILENCER

100 ms

200 ms

300 ms

400 ms

500 ms

600 ms

700 ms

800 ms

900 ms

1 sec

1.1 sec

1.2 sec

1.3 sec

1.4 sec

light

dark

LED Blinking Patterns

Ignition

LED

ICU–L 6–8.4V C onnect LED indicator to the ignition

box (red/black wire to “+”).

U sing the included connector, plug your

battery pack into the ignition box.

F ive seconds after connecting the bat-

tery, the LED indicator should go out.

If the LED is blinking after you connect

the battery, the battery’s voltage is

too low.

LED

7795.3_EVO.gas.manual.Final.indd8 8 7/19/06 4:41:24 PM

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Evolution-engines 35GT2 Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Evolution-engines 35GT2